Leaqio.com
NurdRage from patreon
NurdRage patreon

Lab Notes - August 31st - Nitric Acid from Calcium Nitrate and My Hotplate Failed, Again.

🕑 Added 2020-08-30 08:30:01 +0000 UTC
Lab Notes -  August 31st - Nitric Acid from Calcium Nitrate and My Hotplate Failed, Again.

Comments

Jrandom Bob

Alternatively just grab some kind of uninsulated crimp terminal, cut the crimp bit out and use that ;)

philpem

Nice video, short and sweet :) If your copper tape fix doesn't hold, there's a method often used on 3D printers which might help you. Take a bootlace ferrule and remove the plastic part. Keep the metal tube. Push the wire in one side and the Pt1000 lead into the other. Crimp it -- either use a ferrule crimper or a pair of pliers. This is often done on 3D printer hot-end temperature sensors, which can reach 300C or more.


More Creators