ToHardware
patreon
Release 001 - First Generation Starter AC VER. 1.2
🕑 Added 2023-07-21 07:10:57 +0000 UTCThis is an update for the First Generation Starter AC.
What's updated with this release?
- replaced all Lychee files with only STLs
- created a .1mm tolerance set of parts for resin printers with a PPI of 500 or more
- merged all rivet pieces with the parts to eliminate wasted resin from potential print failures
- adjusted the jaw guards for the HD-GRY-NX head
- completely redesigned the XCA-00 core and its assembly.
- fixed an issue where the AN-201's forearm was challenging to assemble when inserting the elbow joint
- fixed an issue where the LN-1001-PX-0's shin section did not have a proper mortise for the knee's corresponding tenon joint
- fixed an issue where the LN-1001-PX-0's shin insert had incorrect dimensions preventing proper assembly
- fixed the assembly of the WM-S04-1 where the entire body is now one whole piece in an effort to eliminate unsightly seam lines.
- fixed the design of the WM-S04-1 launch and exhaust tubes
In the download you will find the following files and information:
- 500+ PPI Resin Pre-Supported STL files of the Starter AC
- 800+ PPI Resin Pre-Supported STL files of the Starter AC
- Instruction Manual
If your printer is between 500 and 750 PPI, use the 500+ PPI files
If your printer is between 800 and 1250 PPI, use the 800+ PPI files
Those of you who are interested in printing these via FDM; I will be trying to get FDM versions of all releases handled by the time the Third Generation Starter AC has been made.
EDIT: Release has been deprecated
Comments
Victor Rivera
Awesome! Thanks! 🔥🔥🔥🔥
