squirrelf3d
patreon
Apollo on Rail + chain + Orbiter 2.0 + BTT/Mellow FLYSHT36 CAN setup
🕑 Added 2022-11-25 21:29:06 +0000 UTCTweaked the attached two files to accommodate
Apollo on Rails
+Mellow FLY SHT 36 (Very likely the BTT model as well, but haven't actually checked)
+ Orbiter 2.0 (motor facing back)
+ Drag Chain
----
Dec 4 - UPDATE
- updated the orbiter 2.0 fly sht36 mount
- Added the sherpa fly sht36 mount
- added mounting tubes, and check renders for heat inserts position
Use long enough screws to go into the tubes
Orbiter
M3x20 on the orbiter side
All M3x8 on the fly sht36 set side
Sherpa
M3x16 on both sides of the tube
----
Now in the Apollo Master Zip
https://www.patreon.com/posts/apollolander-and-71090737
Comments
Squirrelf
Thanks for the info. Haven't had a chance to try it myself. Was merely a remix. But was tested on rails and working with rigid mounted hotend and v6 as they are pushed further forward, leaving more space behind. On rail and stock hotend was barely working from another report.
I finally got a chance to test this, but on wheels. The heatsink definitely would never clear. The wiring barely clears, but only with good cable management and I had to bend the Dupont pins into an L shape with no housings on them for the probe. It works though. I'm assuming the clearance with a linear rail is much better.
Squirrelf
Give this a try and let me know how it goes!
I would love to see this with Sherpa mini if it's at all possible.
