squirrelf3d
patreon
Small box for bolts, nuts, etc... (STL/STEP)
🕑 Added 2022-05-15 17:49:22 +0000 UTCI needed something asap, so it's nothing fancy, and not extensively tested.
Not sure if there is any interest for this, but decided to post it anyway.
my only requirements were that it snapped shut, easy enough to reopen and screws didn't jump compartments when closed. If full and you shake it violently upside down without holding the lid or falls it will very likely open. So if you want something that doesn't open when falling, this is not it.
Walls are 1.2mm, so roughly 3 lines on 0.4 nozzle, but 0.6mm nozzle would be two lines and a faster print, but not sure if the clasp would still work, probably would, just no guaranties.
Only tested with a 0.4 nozzle at 0.3mm layer height
overall dimension
ID about 60x122mm
OD about 65x130mm
larger compartment are roughly 40x30mm
and 29x29mm for the smaller ones
included 3 different version:
8 equal small compartment
7 compartment - 4 small on one side, and thirds on the other (STEP file is this model, and render above)
5 compartment - 4 small on one side, and a large full length on the other
STEP file included so you can move the compartments around easily and etch text on the lid, etc
