squirrelf3d
patreon
Apollo Mini (dual 4010)
🕑 Added 2023-02-26 06:39:29 +0000 UTCFinally finished it. (and thanks to KtotheStank for testing it)
I made it so that I can relatively easily convert any Apollo currently supported hotend into one of these. So feel free to submit requests
Front fan is a 4020, but spacer included for a 4010
Currently supported
- Dragonfly BMS
- Stock Creality / Microswiss
- DropEffect XG
- Bambulab Hotend
- NF Crazy & Magnum (original not plus or pro)
- Mosquito & Mosquito Magnum
- Taichi
Supported Direct drive setup (and of course bowden)
- Orbiter 1.5
- Orbiter 2.0
- Sherpa Mini
- Sherpa Micro
- BMG
- Vz-Hextrudort-Low
Mount - same as Apollo
- stock backplate on wheels
- linear rails (front mounted)
- BTT hermit crab
All the render in the zip are pulled from the apollo zip. but the similarity should make sense.
Fans are held without screws.
------
rev1.1 - Feb 25, 2023
made left fan, easier to install
rev 1.2 - Feb 26, 2023
"dual ears" model for left (or dual) handed cable routing.
rev 1.3 - Feb 26, 2023
Added bambulab hotend
rev 1.4 - Feb 28, 2023
Added Mosquito and NF crazy
rev 1.52 - Mar 11, 2023
Added Taichi - dual direct drive (orbiter 2 or sherpa )
rev 1.61 - Mar15
cleaned up the zip tie holes, and small missing piece left of the front fan
added a revised bltouch mount - untested
NF crazy Magnum
rev 1.7 - Mar 18, 2023
Added dragonfly BMO
rev 1.8 - Mar 21
Added beacon mount, ducts to go with it will come soon. (if you have one let me know and I'll do it sooner)
Added Stock bowden setup with large opening on top.
rev 1.9
Added v6/revo6 model (wheels setup only, send a request for linear rail model, as it's not a strait forward update)
Updated CRtouch mount (brings the CRtouch closer to the body)
Comments
Squirrelf
Yeah the mini is really cute! I only made it because I had request for it, but most of the time its because people didn't have 5015 fans or just prefer the looks of it. The weight reduction is minimal only 25g
Jon Singh
Hi, love these prints, debating between the mini and the original, is the mini mostly for weight reduction?
Squirrelf
that is correct (and while looking at it noticed I left the old rev of the main body, will remove it for next zip upgrade)
Brent
So if I was putting together a new Ender 3 w/ Orbiter DD, I'd need just these printables: left duct - baseline right duct - baseline BLtouch baseline - side - rev2.1 main body - stock - rev1.4 stock_cable_guide e3_backplate_Orbiter2.0_front_motor
