matmire_makes
patreon
Bonus: Rattlesnake Keychain & Magnet!
🕑 Added 2023-01-07 23:07:05 +0000 UTCHey All!
You knew it had to happen. Now you can print your own Rattlesnake Rattle Keychains! I'm including two versions... a single print "Full" version, and a two piece version, in case you want to do a little mix and match with the colors. Also, we have a fancy new Fridge Magnet that keeps the hinged mouth of the full model!
Enjoy!
Matt
**Download from the Pinned "Current Download Links" post**
Print Settings For Magnet:
- 0.16mm layer height
- 3 walls with a 0.4mm nozzle (could do 2 walls with a larger nozzle.)
- 10% Lightning infill (lightning infill is great for these because it keeps the weight down and only creates infill where needed. Keeping the weight down helps the magnets be more effective.)
- 5-6 bottom layers (gives a little extra strength to the magnet attachment area.)
- If your printer struggles with bridging, you may need to add support inside the magnet slot. Give it a try without and see how it goes.
Print Settings For Keychain:
- 3 walls with a 0.4mm nozzle (could do 2 walls with a larger nozzle.)
-10% infill (preferably not Lightning)
**Download from the Pinned "Current Download Links" post**
Comments
Great suggestion, Thanks Mat
MatMire_Makes
That’s going to depend a lot on individual printer tolerances, but I’ll take a look at it. In the meantime, you could heat the upper head a little bit and gently squeeze the joints a little closer together. Just let it cool before snapping it back together.
These are great Mat, anyway to tighten up the joint so the mouth stays open?
D&K CUSTOM PRINTS
Great, thanks for the reply! 😊
MatMire_Makes
I think I would do the Keychain the same as a full model, for durability. Basically, don't use Lightning infill.
D&K CUSTOM PRINTS
can't wait to print these! Are the print settings the same for the keychain as the magnet?
