Iain Davies
patreon
SlipLok case
🕑 Added 2025-11-03 18:19:55 +0000 UTC Hello members, new and old.
Here is the SlipLok case!
This one's for 256x256 and larger build plates, such as on the Bambu, but I'll split it up for smaller ones in the next day or two.
I'll send it to everyone who was a member this month by MyMiniFactory at the end of the month :-)
Until then, enjoy!
Comments
Iain Davies
It's intended as more of a display case so the plasticars is recommended but I will make alternatives, yes.
Otis Viles
The instructions say the plasticard is optional but without it the case is open; I’m guessing one of the additional faces will be solid and not a frame?
Iain Davies
Tap A for auto-arrange. It'll put it in the right place.
Howard Katz
Hi, Thanks for sending. I have a P1S and I’m getting an error on the case.stl that it’s to close to the exclusion area.. Thoughts? Thanks, Howard
